Chapter 15.70
FENCES

Sections:

15.70.010    Intent and purpose.

15.70.020    Maximum height.

15.70.030    Setback requirements.

15.70.040    Masonry or block-stone wall.

15.70.050    Material (fence construction).

15.70.010 Intent and purpose.

This chapter is intended to preserve the character and value of real property within the limits of the town and to promote the peace, comfort, convenience and welfare of all inhabitants of the town. (Ord. 94-015, 1994; prior code § 8-10-1)

15.70.020 Maximum height.

The maximum height of fences measured from highest grade on either side of the fence shall be:

A. Maximum four feet above grade front yard extending to the front corner of the house on side parcel lines, may include the rear portion of the lot to include complete parcel dimensions.

B. Maximum six feet above grade fence shall encompass the back and side parcel lines but shall not extend past the front side corners of the house.

C. Maximum eight feet above grade fence within a commercial, industrial or public works facility, where such property requires security. Temporary or construction fencing may exceed the eight-foot limit but not more than 10 feet respectively. (Ord. 94-015, 1994; prior code § 8-10-2)

15.70.030 Setback requirements.

Fence setback requirements are as follows:

A. Side fence lines shall not extend over the property line, nor extend past front or rear easements.

B. Front and rear fence lines will be regulated by the town easement restrictions. (See town for exact setback requirements.) (Ord. 94-015, 1994; prior code § 8-10-3)

15.70.040 Masonry or block-stone wall.

To construct a masonry or block-stone wall:

A. Requires a building permit from the town building department or town clerk.

B. Footers are required and shall be inspected by the building inspector prior to construction of a masonry-type fence.

C. An inspection is required after completion. (Ord. 94-015, 1994; prior code § 8-10-4)

15.70.050 Material (fence construction).

A. Fencing shall be constructed of proper recommended fencing material (of noninfestation material), which includes but is not limited to wood specifically treated or used for fencing, i.e., redwood, cedar and other woods that have been treated for insect and rot retardation.

B. A fence post shall not exceed six-inch by six-inch dimensions.

C. A post shall be set not less than two feet below grade.

D. In residential areas that do not have alleys or open utility easements in the rear of the lots, fencing must be of a noncombustible material. (Ord. 94-015, 1994; prior code § 8-10-5)