$1.00 to $500.00

$23.50

$501.00 to $2,000.00

$23.50 for the first $500.00 plus $3.05 for each additional $100.00, or fraction thereof, to and including $2,000.00

$2,001.00 to $25,000.00

$69.25 for the first $2,000.00 plus $14.00 for each additional $1,000.00, or fraction thereof, to and including $25,000.00

$25,001.00 to $50,000.00

$391.25 for the first $25,000.00 plus $10.10 for each additional $1,000.00, or fraction thereof, to and including $50,000.00

$50,001.00 to $100,000.00

$643.75 for the first $50,000.00 plus $7.00 for each additional $1,000.00, or fraction thereof, to and including $100,000.00

$100,001.00 to $500,000.00

$993.75 for the first $100,000.00 plus $5.60 for each additional $1,000.00, or fraction thereof, to and including $500,000.00

$500,001.00 to $1,000,000.00

$3,233.75 for the first $500,000.00 plus $4.75 for each additional $1,000.00, or fraction thereof, to and including $1,000,000.00

$1,000,001.00 and up

$5,608.75 for the first $1,000,000.00 plus $3.15 for each additional $1,000.00, or fraction thereof

Other Inspections and Fees:

Hourly Charge

1.

Inspections outside of normal business hours    

$47.00 per hour*

(Minimum charge – two hours)

2.

Investigation/Reinspection fees assessed under provisions of Section 108.8    

$47.00 per hour*

3.

Inspections for which no fee is specifically indicated    

$47.00 per hour*

(Minimum charge – one-half hour)

4.

Additional plan review required by changes, additions or revisions to plans    

$47.00 per hour*

5.

For use of outside consultants for plan checking and inspections, or both    

Actual costs**

For issuing each permit

$25.40

For issuing each supplemental permit

$12.70

For each plumbing fixture on one trap or a set of fixtures on one trap (including water, drainage piping and backflow protection therefor)

$8.89

For each building sewer and each trailer park sewer

$19.05

Rainwater systems – per drain (inside building)

$8.89

For each cesspool (where permitted)

$31.25

For each private sewage disposal system

$50.80

For each water heater and/or vent

$8.89

For each gas-piping system of one to five outlets

$6.35

For each additional gas-piping system outlet, per outlet

$1.27

For each industrial waste pretreatments interceptor including its trap and vent, except kitchen-type grease interceptors functioning as fixture traps

$8.89

For each installation, alteration or repair of water piping and/or water treating equipment, each

$8.89

For each repair or alteration of drainage or vent piping, each fixture

$8.89

For each lawn sprinkler system on any one meter including backflow protection devices

$8.89

For atmospheric-type vacuum breakers not included in above item:

1 to 5

$6.35

Over 5, each

$1.27

For each backflow protective device other than atmospheric-type vacuum breakers:

2 inch (51 mm) diameter

$8.89

Over 2 inch (51 mm) diameter

$19.05

For each graywater system

$50.80

For initial installation and testing of a reclaimed water system

$38.10

For each annual cross-connection testing of a reclaimed water system (excluding initial test)

$38.10*

For each medical gas-piping system serving one to 5 inlet(s)/outlet(s) for a specific gas

$63.50

For each additional medical gas inlet(s)/outlet(s)

$6.35

Inspections outside of normal business hours

$38.10*

Reinspection fee

$38.10*

Inspection for which no fee is specifically indicated

$38.10*

Additional plan review required by changes, additions or revisions to approved plan (minimum charge – one-half hour)

$38.10*

For the issuance of each permit

$23.50

For the issuance of each supplemental permit for which the original permit has not expired, been canceled or finaled

$7.25

Furnaces

For the installation or relocation of each forced-air or gravity-type furnace or burner, including ducts and vents attached to such appliance, up to and including 100,000 Btu/h (29.3 kW)

$14.80

For the installation or relocation of each forced-air or gravity-type furnace or burner, including ducts and vents attached to such appliance, over 100,000 Btu/h (29.3 kW)

$18.20

For the installation or relocation of each floor furnace, including vent

$14.80

For the installation or relocation of each suspended heater, recessed wall heater or floor-mounted unit heater

$14.80

Appliance Vents

For the installation, relocation, or replacement of each appliance vent installed and not included in an appliance permit

$7.25

Repairs or Additions

For the repair of, alteration of, or addition to each heating appliance, refrigeration unit, cooling unit, absorption unit, or each heating, cooling, absorption or evaporative cooling system, including installation of controls regulated by the Mechanical Code

$13.70

Compressors and Absorption Systems

For the installation or relocation of each compressor to and including three horsepower (10.6 kW), or for each absorption system to and including 100,000 Btu/h (29.3 kW)

$14.70

For the installation or relocation of each compressor over three horsepower (10.6 kW) to and including 15 horsepower (52.7 kW), or for each absorption system over 100,000 Btu/h (29.3 kW) to and including 500,000 Btu/h (146.6 kW)

$27.15

For the installation or relocation of each compressor over 15 horsepower (52.7 kW) to and including 30 horsepower (105.5 kW), or for each absorption system over 500,000 Btu/h (146.6 kW) to and including 1,000,000 Btu/h (293.1 kW)

$37.25

For the installation or relocation of each compressor over 30 horsepower (105.5 kW) to and including 50 horsepower (176 kW), or for each absorption system over 1,000,000 Btu/h (293.1 kW) to and including 1,750,000 Btu/h (512.9 kW)

$55.45

For the installation or relocation of each compressor over 50 horsepower (176 kW), or for each absorption system over 1,750,000 Btu/h (512.9 kW)

$92.65

Air Handlers

For each air-handling unit to and including 10,000 cubic feet per minute (4,720 L/s), including ducts attached thereto

$10.65

Note: This fee does not apply to an air-handling unit which is a portion of a factory-assembled appliance, cooling unit, evaporative cooler or absorption unit for which a permit is required elsewhere in the Mechanical Code.

For each air-handling unit exceeding 10,000 cfm (4,720 L/s)

$18.10

Evaporative Coolers

For each evaporative cooler other than portable type

$10.65

Ventilation and Exhaust

For each ventilation fan connected to a single duct

$7.25

For each ventilation system which is not a portion of heating or air-conditioning system authorized by a permit

$10.65

For each installation of each hood which is served by mechanical exhaust, including the ducts for such hood

$10.65

Incinerators

For the installation or relocation of each domestic-type incinerator

$18.20

For the installation or relocation of each commercial-type or industrial-type incinerator

$14.50

Miscellaneous

For each appliance or piece of equipment regulated by the Mechanical Code but not classed in other appliance categories, or for which no other fee is listed in the table

$10.65

Additional plan review required by changes, additions or revisions to approved plans (minimum charge – one-half hour)

$47.00 per hour*

Inspections outside of normal business hours (minimum charge – two hours)

$47.00 per hour*

Reinspection fees assessed under provisions of Section 108.8

$47.00 per hour*

Inspections for which no fee is specifically indicated (minimum charge – one-half hour)

$47.00 per hour*

Residential Demolition

$25.00

Commercial Demolition – per commercial structure

$50.00

Manufactured/Modular (Chassis Construction Only) Placement Permit – per unit

$100.00

Occupancy Inspection

$50.00

Duplicate Permit

$25.00

Duplicate House Plans

$35.00

Same-As Plan Review

$200.00

Sign Permit Fees Based Upon Table 3-B Current Edition

Valuation based

Sign Plan Review Fee

65% of the sign permit fee

State Building Code Fee – per single-family residence – in accordance with RCW 19.27.085

$4.50

State Building Code Fee – per multifamily residence – for every unit except the first unit which will be $4.50

$2.00

Roofing Permit – Dimensional Shingle

$60.00

Roofing Permit – Shake

$100.00

Roofing Permit – Tile/Concrete

$125.00

Roofing Permit – Standard 3-Tab/Architectural

$40.00

Additional Trip Fee

$50.00